Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Markymark
| Posted on Sunday, August 22, 2004 - 01:10 pm: |
|
Went to change the trans oil on the Blast today and upon installing the cover with a torque wrench, pulled the threads out. Anyone else had this problem and if so what kind of repair did you use? |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Ezblast
| Posted on Sunday, August 22, 2004 - 02:48 pm: |
|
Be carefull doing it, however, in the regular KV I read of this happening, and it was sugested that you could helicoil it. Browse the regular KV section and you'll find it. Hope that helps! GT - JBOTDS! EZ![](http://www.badweatherbikers.com/buell/clipart/vader.gif) |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Markymark
| Posted on Sunday, August 22, 2004 - 05:14 pm: |
|
Went ahead and installed a heli-coil. |
|