Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Gearheaderiko
| Posted on Monday, February 16, 2009 - 07:47 pm: |
|
![Seat tab repair](http://www.badweatherbikers.com/buell/messages/20164/436581.jpg) Gluing usually wont hold it. Use a piece of band steel or scrap to make a brace.Use 2 screws to hold it in place. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Bumblebee
| Posted on Tuesday, March 25, 2014 - 11:41 am: |
|
Somehow I don't think this failure is too uncommon. That tang was broken off on both of my Blasts when I got them. In both cases was able to make a repair with a piece of bar aluminum, slid it in where the tab had been (there was a rectangular hole left where the tang used to be) I drilled and threaded the bar stock, drilled a hole in the plastic and put a 10-32 screw through into the tapped hole in the bar stock. Bent the tang down a bit, now it fits perfectly. I'd dare say it's better than factory. |
|