| Author | Message | ||
     Team_flash |
Hey all, since I put my air shifter on I haven't been able to foot shift because my linkage won't work. The linkage I need goes over the derby cover back to the piece that mounts on the footpeg. I need the linkage bar and the lever that mounts to the peg. If you have this and want to sell please let me know 480-766-6347. Thanks | ||
| Hybridmomentspass |
might be able to help for the record - youre wanting the boomerang style, often in the classifieds what are you using now? | ||
| Team_flash |
At this point in time I am not using anything. I hand shift the bike to get into the waterbox and then to make sure I am in first to launch. I use the air shifter to up shift. All I have is the shift lever coming up off of the shifter shaft. I can reach it with my foot to down shift but I really need a full shifter set up | ||
| Hybridmomentspass |
one thing that you could do to make something work for the time being - the bolt to connect the piston on the shifter to the lever off of the tranny- install a peg on it or make one (i did a long bolt with fuel line around it and it worked fine and cost less than a buck at the hardware store including the acorn nut on the end to make sure i didnt catch my leathers etc) I know your situation, and I am working on something, something in my mind, to eliminate the boomerang shifter and give a good foot shifter while still doing an airshifter... its coming | ||
| Team_flash |
I had a bolt off the lever which was decent but I need a better/perm solution. I am working on a solution with a member and am anxious to get the deal done so I have it installed before my race in Sonoma Cali this month | ||
| Hybridmomentspass |
pm me, maybe we're working on the same idea... if not, we could help each other out with a better idea |
