Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Vortec57
| Posted on Thursday, July 16, 2020 - 08:49 pm: |
|
Swapped the race ecm out and back to stock ecm. Now throttle movement makes engine light turn on. I assume I need a tps reset? Can I do this without hooking it to ecmspy? |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Tootal
| Posted on Thursday, July 16, 2020 - 09:32 pm: |
|
Not on an 06. Make sure your butterfly in the throttlebody is clean along the edges so it's fully closing when doing a reset. Warmed up engine usually works best. If it won't run well reset it cold and then reset it again after a ride and see if it improves. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Vortec57
| Posted on Friday, July 17, 2020 - 09:30 am: |
|
Dangit OK. Not only a TPS reset, but I have to put the race ECM back on, as I realized it wont work on my 09 |
|