Author |
Message |
Jhallgren
| Posted on Monday, July 23, 2012 - 03:24 pm: |
|
Does anyone have idea if there is a easy way to get the front breather out without rotating the engine down a little? I need to replace the grommet because it is weeping past the breather stem. The breather fits very loosely in the grommet. If I try to remove the breather, it hits the frame. Not enough clearance to get it out. |
Ratbuell
| Posted on Monday, July 23, 2012 - 04:49 pm: |
|
Pull it out as far as you can. Clean with brakleen. Put a bead of ultra black RTV around the valve and push it back in place. "Fix"? Not really. But a patch that should last a while. |
Davis_bueller
| Posted on Monday, July 23, 2012 - 08:32 pm: |
|
Just take out the front isolator bolt out. This will give you enough room. It's still tight but it works. I found the rear more difficult. |
Jhallgren
| Posted on Tuesday, July 24, 2012 - 10:22 am: |
|
Ratbuell, thats a good idea, I did not even think about that. Thanks guys for the input. |
|