Author |
Message |
Kimberley
| Posted on Monday, August 10, 2009 - 01:46 am: |
|
I cannot for the life of me get the new stock bar ends to go into the handlebars! I've tried dishsoap, WD40 and a hammer. No go. Suggestions?? |
Growl
| Posted on Monday, August 10, 2009 - 02:44 am: |
|
Were the old ons broken off, is there still some in there? |
Mnrider
| Posted on Monday, August 10, 2009 - 11:08 am: |
|
You may have to file the inside of the bar some,mine had a sharp lip on the inside of the bar. |
Spacecapsule1
| Posted on Monday, August 10, 2009 - 12:03 pm: |
|
stick em in the freezer for a while. meanwhile let the bars sit in the sun and heat up....... should go right together after that. |
Thetable
| Posted on Monday, August 10, 2009 - 01:28 pm: |
|
I threw mine in some boiling water for a bit to soften them up, then beat the crap out of them to get them in the bar. You would be very surprised at how hard you can hit them with a dead blow and not cause damage. Just watch out and make sure that you don't have any skin in the area, or it will get pinched. DAMHIK. (Message edited by thetable on August 11, 2009) |
Kimberley
| Posted on Monday, August 10, 2009 - 07:03 pm: |
|
Boiled 'em......went right in. Thanks!!! |
|